Skip to content


Steel Converting
Steel coils are commonly cut into sheets or narrow coils for transport or for specific applications. This cutting or slitting can damage the surface or edges of the metal or cause other surface defects.

Cutting steel creates new edges, possibly with imperfections which could cause damage to later process stages. If undetected, they may result in substandard product reaching the customer. 

Monitoring the steel at each of the conversion stages helps detect any edge or surface defects at an early stage. This supports quality, process efficiency, and prevents the shipping of defective metal.

With extensive experience in the steel industry, AMETEK Surface Vision delivers innovative edge monitoring solutions for metal cutting applications. These are supported by trusted surface inspection systems for high-quality products.
  • Applications +

    • Steel Blanking

      Blanking lines are used to create shaped steel pieces ready for use in automotive and other fabrication applications. Inspection of the blank surface ensures defects are not introduced during this conversion process.

      Keep Reading

    • Steel Cut to Length
      Cut to Length

      Any cutting of metal sheets has the potential to damage the edges. To detect any flaws created by cutting, accurate inspection of the entire surface, including the edges, is required.

      Keep Reading

    • Steel Inspection

      Inspection of the finished product ensures that substandard product is not sent out to customers. Automated inspection systems are more precise than manual methods, and provide a record for later checking.

      Keep Reading

    • Aluminium Extrusion - Billet

      Slitting coils can leave them prone to edge damage. AMETEK Surface Vision provides an advanced edge monitoring system, while also inspecting both sides of the slit metal strip.

      Keep Reading

    • Steel Trimming

      Edge trimming is intended to remove impurities and defects from the edge of the metal strips. AMETEK Surface Vision’s system monitors the metal edge to ensure defect removal.

      Keep Reading